• Fritz!Box 6490 Cable Modem and Router
• Fritz!Box 7490 DSL Modem and Router
• Ubiquiti Edge X Router
• Cisco SG300-28 Managed Switch
• NETGEAR GS305 5-Port Unmanaged Gigabit Switch
• GL AR150-Ext (Runs OpenWrt by default)
• Raspberry Pi
• Ralink WiFi Dongle with RT5370 Chipset (Works in AP mode using hostapd)
• USB Wireless Adapter MediaTek Ralink RT5370N (Works in AP mode using hostapd)

TODO

Without this feature I got only about 300 Mbits data rates to my ISP. Since I have an 1.000 Mbits uplink I needed to enable this feature. With NAT Hardware Offloading I get the full data rate but Deep Packet Inspection (DPI) does not work anymore. Since I do not analyze traffic in any way on my router I don't care about this.

configure
set system offload hwnat enable
commit
save
exit

Manual: https://help.ui.com/hc/en-us/articles/115006567467-EdgeRouter-Hardware-Offloading

• WLAN-Access-Point mit hostapd und USB-Stick (german)
• Raspberry Pi als WLAN-Bridge einrichten (WLAN-Access-Point) (german)
• Raspberry Pi als WLAN-Access-Point einrichten (german)
• Setting up a Raspberry Pi as a WiFi access point - Make the most adorable little WiFi router
• Multiple SSIDs with hostapd
• Onion Pi - Make a Raspberry Pi into a Anonymizing Tor Proxy!
• PiVPN - The simplest way to setup and manage a VPN, designed for Raspberry Pi.
• RetroPie - Retro-gaming on the Raspberry Pi
• OpenWrt GL.iNet GL-AR150
• OpenWrt Ubiquiti EdgeRouter X (ER-X), EdgeRouter X-SFP (ER-X-SFP) and EdgePoint R6 (EP-R6)
• How To Forward Ports through a Linux Gateway with Iptables
• How to enable IP Forwarding in Linux